LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pump Screen and Pickup Tube >> Installation

Oil Pump Screen and Pickup Tube: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install a new O-ring seal on the oil pump screen and pickup tube.
    • Lubricate the O-ring seal with clean engine oil.
  2. Install the oil pump screen and pickup tube.
    1. Position the oil pump screen and pickup tube.
    2. Install the bolts and tighten to 10 Nm (89 lb-in).
      Fig 1: Positioning Oil Pump Screen And Pickup Tube
      G06095614Courtesy of FORD MOTOR CO.
  3. Install the oil pan. For additional information, refer to OIL PAN .
scientia non olet · About LEMON Manuals