LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Clean all sealing surfaces with metal surface prep.
    NOTE: Apply clean engine oil to the seal lip and seal bore before installing the seal.
    Fig 1: Installing Crankshaft Rear Oil Seal
    G06095516Courtesy of FORD MOTOR CO.
  1. Using the Crankshaft Rear Main Oil Seal Installer Bolts and the Crankshaft Rear Main Oil Seal Installer, install the crankshaft rear oil seal.
  2. Install the flexplate. For additional information, refer to FLEXPLATE .
scientia non olet · About LEMON Manuals