LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Accessory Drive System - 2.5L - (Hybrid)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt from the tensioner pulley.
    2. NOTE: The accessory drive belt tensioner must be replaced as a complete unit.
  2. Remove the 3 bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals