LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Coolant Pump Belt >> Removal

Coolant Pump Belt: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
  3. Position the Stretchy Belt Remover under the coolant pump belt as shown.
    Fig 1: Removing Coolant Pump Belt
    G06095744Courtesy of FORD MOTOR CO.
    4. NOTE: Feed the Stretchy Belt Remover on to the camshaft coolant pump pulley approximately 90 degrees.
    Fig 2: Turning Crankshaft
    G06095745Courtesy of FORD MOTOR CO.
  4. With the help of an assistant, turn the crankshaft clockwise and feed the Stretchy Belt Remover evenly on the camshaft coolant pump pulley as shown.
  5. Remove the coolant pump belt.
    • Fold the Stretchy Belt Remover over the top of the coolant pump belt.
    • In one quick motion, pull the Stretchy Belt Remover up and toward the RH front of the vehicle removing the coolant pump belt.
      Fig 3: Removing Coolant Pump Belt
      G06095746Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals