LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  4. Remove the 3 bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
    5. NOTE: Refer to the Fig 1 for correct drive belt routing.
    Fig 1: Rotating Drive Belt
    G06096657Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals