Section 15 (High Voltage Traction Battery)
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Description And Operation
- Diagnosis And Testing
- High-Voltage Traction Battery
- Special Tool(s)
- Principles of Operation
- Inspection and Verification
- DTC Chart
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The High Voltage Traction Battery (HVTB) is Noisy
- Pinpoint Test B: Radio Interference
- Pinpoint Test C: DTC P0A7E - Hybrid Battery Pack Over Temperature
- Pinpoint Test D: DTCs P0A81 and P0A96 - Hybrid Battery Pack Cooling Fans 1 and 2 Control Circuits
- Pinpoint Test E: DTCs P0A8B, P0A8D and P0A8E - 14-Volt Power Module System Voltage
- Pinpoint Test F: DTC P0A27 - Hybrid Battery Power Off Circuit
- Pinpoint Test G: DTC C1862 - Contractor Circuit Failure
- Pinpoint Test H: DTC P0A95 - High-Voltage Fuse
- Pinpoint Test I: DTC B2172 - Inertia Fuel Shutoff (IFS) Switch Input Circuit Open
- Pinpoint Test J: DTC P0A0E - High-Voltage System Inter-Lock Circuit Intermittent
- Pinpoint Test K: DTC P0AA6 - Hybrid Battery Voltage System Isolation Fault
- Pinpoint Test L: DTC P0A1F - Battery Energy Control Module has Internal Errors
- Pinpoint Test M: DTC P0A7D - Hybrid Battery Pack State of Charge Low
- Pinpoint Test N: DTC P2533 - Ignition Switch Run/Start Position Circuit
- Pinpoint Test O: DTC B1143 - Excessive Battery Contractor Close Requests
- Component Tests
- High-Voltage Traction Battery
- General Procedures
- Removal And Installation