LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Electronic Engine Control - 3.0L (4V)) >> Removal And Installation >> Knock Sensor (KS) >> Removal

Knock Sensor (KS): Removal

WARNING: This page is about a different variant/trim than selected.

Cylinder head-mounted Knock Sensor (KS) 

  1. Disconnect the Knock Sensor (KS) electrical connector.
  2. Remove the bolt and the KS.

    Engine block-mounted KS 

  3. Remove the lower intake manifold. For additional information, refer to ENGINE - 3.0L (4V) .
  4. Disconnect the KS electrical connector.
  5. Remove the bolt and the KS.
scientia non olet · About LEMON Manuals