LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Electronic Engine Control - 3.0L (4V)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Installation

Crankshaft Position (CKP) Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the O-ring seal and install new as necessary.
    2. NOTE: Lubricate the CKP sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor and bolt.
    • Tighten to 10 Nm (89 lb-in).
  3. Connect the CKP sensor electrical connector.
  4. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals