LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Electronic Engine Control - 2.5L - (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the PCM cowl seal.
  2. Install the PCM and the 2 bolts.
    • Tighten to 8 Nm (71 lb-in).
  3. Connect the 3 PCM electrical connectors.
  4. Attach the wiring harness retainer to the cowl stud bolt.
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals