Humidity Sensor: Panel/Floor

WARNING: This page is about a different variant/trim than selected.

The HVAC module will transmit an A/C request to the PCM via the IC only if the A/C button is selected.
If the ambient temperature is above approximately 10°C (50°F), the A/C button is selected and the ECON button is not selected, the engine will run continuously and the A/C compressor will cycle per normal A/C compressor operation.
If the ambient temperature is below approximately 10°C (50°F), the A/C button is selected and the ECON button is not selected, the engine will cycle per normal hybrid operation and the A/C compressor will run only while the engine is running.
If the A/C button is selected and the ECON button is selected, the engine will cycle per normal hybrid operation and the A/C compressor will run only while the engine is running.