LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Automatic Transmission Cooler - Transaxle/Transmission Cooling) >> Removal And Installation >> Transmission Fluid Cooler Hoses >> Removal

Transmission Fluid Cooler Hoses: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the lower air deflector.
  3. Remove the transmission fluid cooler tube quick connect secondary latches.
  4. Using the special tool, disconnect the transmission fluid cooler hoses from the tubes.
    5. Fig 1: Disconnecting Transmission Fluid Cooler Hoses From Tubes Using Special Tool 307-569
    GF0000983Courtesy of FORD MOTOR CO.
  5. Remove and discard the transmission fluid cooler hose-to-cooler clamps.
  6. Disconnect the transmission fluid cooler hoses from the cooler.
  7. Remove the transmission fluid cooler hoses from the retainer.
scientia non olet · About LEMON Manuals