LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the valve seal and valve stem with clean engine oil prior to installation.
  1. Position a new valve seal onto the valve stem.
  2. Using the special tool, install the new valve seal.
    3. Fig 1: Installing Valve Seal Using Special Tool (303-383)
    G03920082Courtesy of FORD MOTOR CO.
    CAUTION: If the components are to be reinstalled, they must be installed in their original positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.
  3. Using the special tool, install the valve spring, the valve spring retainer and the valve spring retainer keys.
    4. Fig 2: Compressing Valve Spring With Special Tool (303-1039)
    G03920063Courtesy of FORD MOTOR CO.
  4. Relieve the air pressure from the cylinder.
    5. CAUTION: If the components are to be reinstalled, they must be installed in their original positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.
    NOTE: Do not allow the valve keepers to fall off of the valve or the valve may drop into the cylinder. If a valve drops into the cylinder, the cylinder head must be removed. For additional information, refer to Cylinder Head .
    NOTE: It may be necessary to push the valve down while compressing the spring.
    NOTE: Lubricate the camshaft roller followers with clean engine oil prior to installation.
  5. Using the special tool, compress the valve spring and install the camshaft roller follower.
    6. Fig 3: Identifying Special Tool (303-1039) For Removing/Installing Camshaft Roller Followers
    G03919946Courtesy of FORD MOTOR CO.
  6. Install the spark plug. For additional information, refer to ENGINE IGNITION - 4.6L (3V) .
  7. Depending on the valve seal being serviced, install the LH or RH valve cover. For additional information, refer to Valve Cover - LH  or Valve Cover - RH .
scientia non olet · About LEMON Manuals