LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Oil Pump Screen and Pickup Tube >> Installation

Oil Pump Screen and Pickup Tube: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the O-ring seal is in place and not damaged. A missing or damaged O-ring seal can cause foam in the lubrication system, low oil pressure and severe engine damage.
    NOTE: Clean and inspect the mating surfaces and install a new O-ring seal. Lubricate the O-ring seal with clean engine oil prior to installation.
  1. Position the oil pump screen and pickup tube and install the bolts.
    • Tighten the oil pump screen and pickup tube-to-oil pump bolts to 10 N.m (89 lb-in).
    • Tighten the oil pump screen and pickup tube-to-spacer bolt to 25 N.m (18 lb-ft).
    2. Fig 1: Locating Oil Pump Screen And Pickup Tube And Bolt
    GF0015208Courtesy of FORD MOTOR CO.
  2. Install the oil pan. For additional information, refer to Engine Lubrication Components - Exploded View  and Oil Pan .
scientia non olet · About LEMON Manuals