LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Hydraulic Lash Adjuster >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshafts. For additional information, refer to Valve Train Components - Exploded View  and Camshaft - LH  and Camshaft - RH .
  2. Remove the remaining roller followers from the cylinder head being serviced.
    3. CAUTION: If the components are to be reinstalled, they must be installed in their original positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.
  3. Remove the hydraulic lash adjusters that are being serviced.
  4. Inspect the hydraulic lash adjusters. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION .
    5. NOTE: Lubricate each of the hydraulic lash adjusters with clean engine oil prior to installation.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals