LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Camshaft Roller Follower >> Installation

Camshaft Roller Follower: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: If the components are to be reinstalled, they must be installed in their original positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.
    NOTE: Lubricate the roller follower with clean engine oil.
  1. Using the special tool, compress the valve spring and install the camshaft roller follower.
    2. Fig 1: Identifying Special Tool (303-1039) For Removing/Installing Camshaft Roller Followers
    G03919946Courtesy of FORD MOTOR CO.
  2. Repeat the previous step for each roller follower being serviced.
  3. Depending on the valve being serviced, install the LH or RH valve cover. For additional information, refer to Valve Cover - LH  or Valve Cover - RH  .
scientia non olet · About LEMON Manuals