LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Camshaft Phaser and Sprocket >> Installation

Camshaft Phaser and Sprocket: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
  1. If installing a new camshaft phaser and sprocket, transfer the original scribe mark to the new camshaft phaser and sprocket.
    2. NOTE: The timing chain must be installed in its original position onto the camshaft phaser and sprocket using the scribed marks, or damage to valves and pistons will result.
    NOTE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
  2. Align the scribe marks and position the camshaft phaser and sprocket into the timing chain.
    3. Fig 1: Identifying Scribe Marks Of Camshaft Phaser And Chain
    G03919995Courtesy of FORD MOTOR CO.
  3. If servicing the RH camshaft phaser and sprocket, install the RH camshaft. For additional information, refer to Camshaft - RH .
  4. If servicing the LH camshaft phaser and sprocket, install the LH camshaft. For additional information, refer to Camshaft - LH .
scientia non olet · About LEMON Manuals