LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Mechanical - 4.0L SOHC) >> In-Vehicle Servicing >> Valve Cover - RH >> Installation

Valve Cover - RH: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Clean the valve cover and cylinder head sealing surfaces with metal surface prep. Inspect and install a new gasket as necessary.
  1. Position the RH valve cover and install the 2 bolts and the 4 stud bolts.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
    2. Fig 1: Identifying Valve Cover Bolts Tightening Sequence
    GF0015041Courtesy of FORD MOTOR CO.
  2. Attach the engine wiring and spark plug wiring retainers to the 2 valve cover stud bolts.
  3. Position the wiring harness bracket on the valve cover stud bolt and install the wiring harness bracket bolt to the back of the RH cylinder head.
    • Tighten to 40 Nm (30 lb-ft).
  4. Attach the heater hose retainer to the valve cover.
  5. Connect the PCV valve electrical connector.
  6. Install the PCV tube.
scientia non olet · About LEMON Manuals