LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Mechanical - 4.0L SOHC) >> In-Vehicle Servicing >> Timing Drive Components - Hydraulic Chain Tensioner, LH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Engine Coolant Temperature (ECT) sensor. For additional information, refer to ELECTRONIC ENGINE CONTROLS .
  2. Remove the LH hydraulic chain tensioner.
    • To install, tighten to 44 Nm (32 lb-ft).
  3. Remove and discard the washer.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals