LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Mechanical - 4.0L SOHC) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bolt and the oil level indicator tube.
    • To install, tighten to 11 Nm (97 lb-in).
    • Remove and discard the O-ring seal.
    2. NOTE: Lubricate the O-ring seal with clean engine oil.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals