In-Vehicle Servicing: Flywheel: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Special bolts are used for flywheel installation. Do not use standard bolts.

Position the flywheel. Install the 8 bolts and tighten in the sequence shown in 3 stages.
- Stage 1: Tighten to 13 Nm (115 lb-in).
- Stage 2: Tighten to 50 Nm (37 lb-ft).
- Stage 3: Tighten an additional 90 degrees.

Fig 1: Identifying Flywheel Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

Install the clutch. For additional information, refer to CLUTCH .