LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Mechanical - 4.0L SOHC) >> In-Vehicle Servicing >> Engine Mount - RH >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the Throttle Body (TB). For additional information, refer to FUEL CHARGING AND CONTROLS - 4.0L SINGLE OVERHEAD CAMSHAFT (SOHC) .
  4. Remove the Front End Accessory Drive (FEAD) bracket bolt and install the Engine Lifting Bracket.
    • To install, tighten to 48 Nm (35 lb-ft).
    5. Fig 1: Locating Front End Accessory Drive (FEAD) Bracket Bolt
    GF0015086Courtesy of FORD MOTOR CO.
  5. Remove the 6 pin-type retainers and the radiator sight shield.
    6. Fig 2: Locating Pin-Type Retainers And Radiator Sight Shield
    GF0014987Courtesy of FORD MOTOR CO.
  6. Install the Engine Support Bar.
    7. Fig 3: Identifying Special Tool 303-F072
    GF0015087Courtesy of FORD MOTOR CO.
  7. Remove the engine mount-to-engine bracket mount nut.
    • To install, tighten to 63 Nm (46 lb-ft).
  8. Remove the 4 engine mount bracket bolts and remove the bracket.
    • To install, tighten to 80 Nm (59 lb-ft).
  9. Remove the 2 engine mount bolts and the engine mount.
    • To install, tighten to 70 Nm (52 lb-ft).
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals