LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Mechanical - 4.0L SOHC) >> In-Vehicle Servicing >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  3. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
    4. NOTE: This bolt is torque-to-yield and cannot be reused.
  4. Using the Strap Wrench, hold the crankshaft pulley, remove the bolt and washer.
    5. Fig 1: Holding Crankshaft Pulley Using Special Tool
    G03946937Courtesy of FORD MOTOR CO.
    NOTE: If the pulley bolt is not installed, the tool will bottom out before the pulley is off.
  5. Install the crankshaft pulley bolt 2 to 3 turns. Using the Crankshaft Vibration Damper Removers and the two 8-mm bolts, remove the crankshaft pulley.
    • Discard the crankshaft pulley bolt.
    6. Fig 2: Identifying Special Tool (303-773, 303-101)
    GF0009314Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals