LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Engine Mechanical - 5.4L (4V)) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold - LH .
  3. Remove the oil level indicator.
  4. Remove the oil level indicator tube bolt.
    • To install, tighten to 10 Nm (89 lb-in).
  5. Remove the oil level indicator tube.
    • Discard the O-ring seal.
  6. To install, reverse the removal procedure.
    • Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
scientia non olet · About LEMON Manuals