LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Engine Mechanical - 5.4L (4V)) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the inner lip of the crankshaft rear seal with clean engine oil.
  1. Using the Crankshaft Rear Oil Seal Installers, install the crankshaft rear seal.
    2. Fig 1: Using Special Tools To Install New Crankshaft Rear Seal
    G04583928Courtesy of FORD MOTOR CO.
  2. Using the Crankshaft Rear Oil Slinger Installer, install the crankshaft rear oil slinger.
    3. Fig 2: Installing Crankshaft Rear Oil Slinger Using Special Tool (303-517)
    GF0000460Courtesy of FORD MOTOR CO.
  3. Install the flywheel. For additional information, refer to Flywheel .
scientia non olet · About LEMON Manuals