LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Body Panel System - Uni-Body System, SUBFRAME System & Mounting System) >> Removal And Installation >> Support Braces - Rear >> Removal

Support Braces - Rear: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The 2 rear support braces must be removed and installed at the same time.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove and discard the 4 rear support brace bolts (rear).
  3. Remove and discard the 2 rear support brace bolts (upper).
  4. Remove and discard the 4 rear support brace bolts (front).
  5. Remove and discard the 2 rear support brace bolts (center to frame), and remove the 2 rear support braces.
scientia non olet · About LEMON Manuals