Extension Housing Seal: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the extension housing seal is correctly installed onto the special tool and the garter spring is in the correct position.

Using the special tool, install the new extension housing seal.

Fig 1: Identifying Special Tool (205-115)

Courtesy of FORD MOTOR CO.

Using the special tools, install the output flange.

Fig 2: Installing Output Shaft Flange Using Special Tools (307-404) & (205-479)

Courtesy of FORD MOTOR CO.

Install a new nut.
- Tighten to 130 Nm (96 lb-ft).

Fig 3: Removing Driveshaft Nut

Courtesy of FORD MOTOR CO.

Install the 4 transmission crossmember-to-floor pan screws only.
- Tighten to 63 Nm (46 lb-ft).

Fig 4: Locating Transmission Crossmember-To-Floor Pan Screws

Courtesy of FORD MOTOR CO.

Install the driveshaft. For additional information, refer to DRIVESHAFT .
Check the transmission fluid level. For additional information, refer to Transmission Fluid Level Check .