Glass Reseal - Rear
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
Material
| Item | Specification |
|---|---|
| DOW AUTOMOTIVE 2-HOUR CURE |
|
| Dow Urethane Adhesive Betaseal® Express |
- |
| SIKA 2-HOUR CURE |
|
| Sika Urethane Adhesive Sika Tack ASAP |
- |
| Ultra-Clear Spray Glass Cleaner ZC-23 |
ESR-M14P5-A |
- Remove the parcel shelf. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the rear window glass electrical connectors.
- Clean the interior and exterior of the rear window glass surface with glass cleaner.
- Cut the urethane adhesive applicator tip to specification.
- Apply urethane adhesive over top of the existing urethane adhesive.
- Apply the urethane adhesive to the top and sides of the rear window glass from the interior of the vehicle.
- Apply the urethane adhesive to the bottom of the rear window glass from the exterior of the vehicle (with the luggage compartment lid open approximately 45 degrees).
- After the urethane has cured, check the rear window glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.
- Connect the rear window glass electrical connectors.
- Install the quarter trim panels and parcel shelf. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
NOTE:
Use either a high-ratio, electric or battery-operated caulk gun that applies the urethane adhesive with less effort and a continuous bead.
NOTE:
Make sure all gaps in the urethane adhesive are smoothed into one continuous bead.
NOTE:
The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.