LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Handles, Locks, Latches & Entry Systems) >> Removal And Installation >> Door Latch >> Removal

Door Latch: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: LH side shown, RH side similar.
  1. Remove the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Disconnect the exterior door handle actuating rod.
    4. Fig 1: Locating Exterior Door Handle Actuating Rod
    GF0014846Courtesy of FORD MOTOR CO.
  4. Remove the 3 door latch bolts.
  5. Disconnect the manual lock rod.
    6. Fig 2: Identifying Manual Lock Rod
    GF0014847Courtesy of FORD MOTOR CO.
  6. If equipped, disconnect the door lock cylinder actuating rod.
    7. Fig 3: Locating Door Lock Cylinder Actuating Rod
    GF0014848Courtesy of FORD MOTOR CO.
  7. Disconnect the 2 wiring harness electrical connectors.
    8. Fig 4: Locating Wiring Harness Electrical Connectors
    GF0014849Courtesy of FORD MOTOR CO.
  8. Remove the cable cover.
    • Release the clip.
    • Remove the pin-type retainer.
    9. CAUTION: Make sure the interior door handle actuating cable does not kink or damage to the cable may occur.
  9. Disconnect the interior door handle actuating cable.
    10. Fig 5: Locating Interior Door Handle Actuating Cable
    GF0014850Courtesy of FORD MOTOR CO.
  10. Remove the door latch.
scientia non olet · About LEMON Manuals