LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC Climate Control System) >> Removal And Installation >> Plenum Chamber >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Remove the RH floor duct screw and the RH floor duct.
  3. Remove the LH floor duct screw and the LH floor duct.
  4. Remove the 4 defroster duct screws.
  5. Detach the 2 demister ducts from the defroster duct.
  6. Remove the defroster duct.
  7. Remove the 2 defrost mode door actuator screws and position the defrost mode door actuator aside.
  8. Remove the 2 panel mode door actuator screws and position the panel mode door actuator aside.
  9. Remove the 2 plenum chamber bolts.
  10. Remove the 2 plenum chamber screws.
  11. Remove the plenum chamber.
  12. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals