Removal And Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.
- Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
- Remove the power steering fluid reservoir bolt.
- To install, tighten to 9 Nm (80 lb-in).
- Release the clamp and disconnect the power steering pump supply hose from the power steering fluid reservoir.
- Release the clamp, disconnect the fluid return hose and remove the power steering fluid reservoir.
- To install, reverse the removal procedure.
- Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION .