LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Exterior Lighting System) >> Removal And Installation >> Reversing Lamp Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the electrical connector and remove the reversing lamp switch.
    • To install, tighten to 37 Nm (27 lb-ft) (T5OD transmission).
    • To install, tighten to 27 Nm (20 lb-ft) (TR3650 or TR6060 transmission).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals