LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear) >> In-Vehicle Servicing >> Rear Wheel Bearing and Axle Shaft Seal >> Removal

Rear Wheel Bearing and Axle Shaft Seal: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shaft. For additional information, refer to Axle Shaft .
    2. NOTE: If the axle shaft oil seal is leaking, the axle housing vent may be plugged.
  2. Using the Slide Hammer and Axle Bearing Remover, remove the rear wheel bearing and axle shaft oil seal.
    3. Fig 1: Removing Rear Wheel Bearing & Axle Shaft Oil Seal Using Special Tools 100-001 & 205-219
    GF0015333Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals