Axle Shaft: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the lip of the axle shaft oil seal with grease.

NOTE: Do not damage the axle shaft oil seal.

Install the axle shaft.

Fig 1: Locating Axle Shaft

Courtesy of FORD MOTOR CO.

NOTE: Do not damage the rubber O-ring in the U-washer groove.

Install the axle shaft U-washer.
1. Position the U-washer on the button end of the axle shaft.
2. Pull the axle shaft outward.

Fig 2: Installing Axle Shaft U-Washer

Courtesy of FORD MOTOR CO.

NOTE: If a new differential pinion shaft lock bolt is unavailable, coat the threads of the old differential pinion shaft lock bolt with threadlock and sealer.

Install the differential pinion shaft.
- Align the hole in the differential pinion shaft with the differential case lock bolt hole.
- Install a new differential pinion shaft lock bolt.
  - Tighten to 30 Nm (22 lb-ft).

Fig 3: Identifying Differential Pinion Shaft Lock Bolt

Courtesy of FORD MOTOR CO.

NOTE: Be sure to apply anti-seize lubricant to the sensor body where it will make contact when installed.

Install the anti-lock sensor.
- To install, tighten to 7 Nm (62 lb-in).

Fig 4: Identifying Anti-Lock Sensor & Bolt

Courtesy of FORD MOTOR CO.

Install the brake disc. For additional information, refer to REAR DISC BRAKE .
Install the differential housing cover. For additional information, refer to Differential Housing Cover .