LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Accessory Drive System) >> Removal And Installation >> Accessory Drive Belt Tensioner - 4.6L (3V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Bullitt vehicles 

  1. Remove the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.

    2. All vehicles 

  2. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the accessory drive belt tensioner.
  3. Remove the 3 bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals