Symptom Chart - Noise, Vibration & Harshness (NVH) - Column Shift

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Noise, vibration and harshness (NVH) symptoms should be identified using the diagnostic tools that are available. For a list of these tools, an explanation of their uses and a glossary of common terms, refer to NOISE, VIBRATION & HARSHNESS article. Since it is possible any one of multiple systems may be the cause of a symptom, it may be necessary to use a process of elimination type of diagnostic approach to pinpoint the responsible system. If this is not the causal system for the symptom, refer back to NOISE, VIBRATION & HARSHNESS article for the next likely system and continue diagnosis.

Condition	Possible Sources	Action
Vibration - a high frequency (20-80 Hz) that is felt through the seat or selector lever. Changes with engine speed	Selector lever cable incorrectly routed, grounded out or loose	CHECK the selector lever cable. REPAIR as necessary. REFER to Selector Lever Cable and Bracket - Column Shift .
Rattle, noise, buzz or other noise	Selector lever Steering column shrouds	INSPECT the selector lever and shrouds for damage and incorrect installation. REFER to Selector Lever - Column Shift .