Seat - Front: Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Position the seat in the vehicle and safety belt anchor to the seat mounting stud.
Connect the electrical connectors and attach the wiring harness pin-type retainer to the seat track.

Fig 1: Seat Electrical Connectors

Courtesy of FORD MOTOR CO.

Install the inboard seat-to-floor nut.
- Before installing the inboard seat-to-floor nut, make sure the center seat safety belt buckle anchor is correctly positioned to the seat track and seat mounting stud.
- Tighten to 80 Nm (59 lb-ft).
Install the outboard seat-to-floor nut.
- Tighten to 25 Nm (18 lb-ft).
Install the 2 rear front seat track covers.
Install the 2 seat-to-floor bolts.
- Tighten to 25 Nm (18 lb-ft).
Install the 2 seat track front covers.
Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.