Seat Cushion - Front: Assembly

Passenger seat 

1. Install the OCS system components. For additional information, refer to Occupant Classification Sensor procedure in SUPPLEMENTAL RESTRAINT SYSTEM article.

All seats 

2. Install the cushion support to the cushion frame.
3. Install the seat cushion trim cover to the foam pad.
4. Position the mat over the cushion support and install the 2 pushpins.
5. Install the frame.

Heated seats 

6. Slide the heated seat module onto the bracket until fully seated.
Fig 1: Heated Seat Module Locking Tab
Courtesy of FORD MOTOR CO.
7. Connect the heated seat module electrical connector.
Fig 2: Heated Seat Module Electrical Connector
Courtesy of FORD MOTOR CO.
8. Connect the cushion heater mat electrical connector.
Fig 3: Cushion Heater Mat Electrical Connector
Courtesy of FORD MOTOR CO.

All seats 

9. Fasten the cushion trim cover retainers.
   1. Fasten the J-clips.
   2. Install the pin-type retainer.
Fig 4: Cushion Trim Cover Retainers
Courtesy of FORD MOTOR CO.
10. If equipped with power lumbar:
    • connect the power lumbar electrical connector.
    • install the power lumbar switch bezel.
11. If equipped, install the seat armrest and bracket.
    • Install the armrest bracket, 3 bolts and cover.
    • Install the armrest.
    • Install the armrest pin, retaining clip and covers.
12. Install the seat track. For additional information, refer to Seat Track .
13. Install the front seat backrest. For additional information, refer to Seat Backrest - Front .
14. Install the seat. For additional information, refer to Seat - Front .