Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Remove the 8 license plate housing nuts.
Disconnect the license plate housing electrical connector.
Remove the 2 screws and the license plate.

Grand Marquis

Remove the 2 screws and the license plate housing.

Fig 1: Identifying License Plate Housing Screws (Grand Marquis)

Courtesy of FORD MOTOR CO.

Crown Victoria

Remove the 4 screws and the license plate housing.

Fig 2: Identifying License Plate Housing Screws (Crown Victoria)

Courtesy of FORD MOTOR CO.

All vehicles

To install, reverse the removal procedure.