LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Supplemental Restraint System) >> Removal And Installation >> Side Impact Sensor >> Removal

Side Impact Sensor: Removal

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
  2. Remove the front door scuff plate.
  3. Remove the rear door scuff plate.
  4. Release the front and rear door B-pillar weatherstripping.
  5. Pull out to release the retaining clips and remove the lower B-pillar trim panel.
    6. NOTE: The side impact sensor bolts must be removed in the sequence shown in illustration.
  6. Remove the side impact sensor with bracket.
    1. Disconnect the electrical connector.
    2. Remove the bolt.
    3. Remove the bolt.
    4. Remove the side impact sensor with bracket.
    7. Fig 1: Side Impact Sensor Bolts Removal Sequence
    GF0013299Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals