LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Windows & Glass - Glass, Frames & Mechanisms) >> Removal & Installation >> Window Glass - Rear Quarter >> Installation

Window Glass - Rear Quarter: Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure to install the quarter window glass into the glass channel.
  1. Position the quarter glass into the door frame.
  2. Fig 1: Quarter Glass In Door Frame
    GF0013206Courtesy of FORD MOTOR CO.
    NOTE: For correct rear door glass fit and function, the glass run division bar locator must be fully forward in the rear door header notch.
  3. Install the window division bar.
  4. Push the run firmly into the C-pillar flange.
  5. Fig 2: Rear Door Top Glass Run In C-Pillar
    GF0013207Courtesy of FORD MOTOR CO.
  6. Install the run at the B-pillar upper corner.
  7. Fig 3: Rear Door Top Glass Run In B-Pillar
    GF0013208Courtesy of FORD MOTOR CO.
  8. Push the run into the B-pillar flange.
  9. Fig 4: Seating Rear Door Top Glass Run In B-Pillar
    GF0013209Courtesy of FORD MOTOR CO.
  10. Push the run into the header of the door.
  11. Fig 5: Seating Rear Door Top Glass Run In Header
    GF0013210Courtesy of FORD MOTOR CO.
  12. Install the side glass into the glass run. For additional information, refer to Window Glass - Rear Door .