Vehicle Dynamic Suspension
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
The vehicle dynamic suspension consists of the following components:
- Air compressor
- Air spring
- Air suspension height sensor (rotary type)
- Air suspension switch
- Air tubes
- Compressor canister
- Compressor drier
- Solenoid valve
- Vehicle Dynamics Module (VDM)
- Wheel studs
The vehicle dynamic suspension system uses an electric pump to pressurize air springs which replace the traditional coil springs. The programmed vehicle ride height is controlled by a VDM which receives a signal from suspension mounted height sensors. The purpose of the vehicle dynamic system is to provide smooth ride quality and a self-leveling suspension. A switch allows for the system to be turned ON or OFF.