LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Accessory Drive System) >> Removal And Installation >> Accessory Drive Belt TENSIONER >> Installation

Accessory Drive Belt TENSIONER: Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accessory drive belt tensioner.

    Tighten the bolt in 2 stages:

    • Stage 1: Tighten to 10 N.m (89 lb-in).
    • Stage 2: Tighten an additional 90 degrees.
    2. Fig 1: Accessory Drive Belt Tensioner
    GF0013749Courtesy of FORD MOTOR CO.
  2. Install the accessory drive belt. For additional information, refer to Accessory Drive Belt  .
scientia non olet · About LEMON Manuals