LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Automatic Transmission) >> In-Vehicle Servicing >> Transmission Insulator And Retainer >> Removal

Transmission Insulator And Retainer: Removal

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. Remove the transmission support crossmember. For additional information, refer to Transmission Support Crossmember .
  2. Remove the transmission support insulator.
    3. Fig 1: Rear Transmission Insulator Bolts
    GF0013675Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
    • Tighten to 90 Nm (66 lb-ft).
    4. Fig 2: Rear Transmission Insulator Bolts
    GF0014077Courtesy of FORD MOTOR CO.
    WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  4. If equipped with a fire suppression system, repower the system.
scientia non olet · About LEMON Manuals