LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Automatic Transmission) >> In-Vehicle Servicing >> Transmission Filler Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the bolt.
    3. Fig 1: Transmission Filler Tube Bolt
    GF0014042Courtesy of FORD MOTOR CO.
  3. Remove the fluid filler tube.
    4. Fig 2: Transmission Filler Tube
    GF0014043Courtesy of FORD MOTOR CO.
    WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  4. To install, reverse the removal procedure. If equipped with a fire suppression system, repower the system.
    • Tighten to 48 Nm (35 lb-ft).
    5. Fig 3: Transmission Filler Tube Bolt
    GF0014044Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals