LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Automatic Transmission) >> In-Vehicle Servicing >> 1-2 Accumulator >> Installation

1-2 Accumulator: Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the 1-2 accumulator.
    1. Install the 1-2 accumulator upper spring.
    2. Install the accumulator piston.
    3. Install the inner and outer lower 1-2 accumulator spring.
    4. Install the cover and seal assembly.
    2. Fig 1: Identifying 1-2 Shift Accumulator Assembly
    GF0003534Courtesy of FORD MOTOR CO.
  2. Compress the accumulator and install the accumulator piston retaining ring.
    3. Fig 2: Locating Accumulator Piston Retaining Ring
    G03888654Courtesy of FORD MOTOR CO.
  3. Install the transmission fluid pan and filter. For additional information, refer to Fluid Pan, Gasket and Filter .
    4. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  4. If equipped with a fire suppression system, repower the system.
scientia non olet · About LEMON Manuals