Torque Converter Diagnosis: Notes
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name |
|---|---|
| Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool |
WARNING:
If equipped with fire suppression system, refer to FIRE SUPPRESSION SYSTEM
article for Important Safety Warnings. Failure to follow this instruction may result in serious personal injury.
Prior to new torque converter installation, all diagnostic procedures must be followed. This is to prevent the unnecessary installation of new or remanufactured torque converters. Only after a complete diagnostic evaluation can the decision be made to install a new torque converter.
Begin with the normal diagnostic procedures as follows:
- Preliminary inspection.
- Know and understand the customer concern.
- Verify the condition - carry out the torque converter operation test.
- Carry out diagnostic procedures.
- Carry out On-Board Diagnostic (OBD); refer to DIAGNOSTIC TESTS
.
- Repair all non-transmission related DTCs first.
- Repair all transmission DTCs.
- Rerun OBD to verify repair.
- Carry out Line Pressure Test. Refer to Special Testing Procedures .
- Carry out Stall Speed Test. Refer to Special Testing Procedures .
- Carry out Diagnostic Routines. Refer to Diagnosis By Symptom .
- Use the Diagnosis by Symptom Chart to locate the appropriate routine that best describes the symptom(s). The routine will list all possible components that may cause or contribute to the symptom. Check each component listed; diagnose and repair as required before changing the torque converter.
- Carry out On-Board Diagnostic (OBD); refer to DIAGNOSTIC TESTS
.