LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Front Suspension) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 4) to allow the wheel stud to fully seat against the hub flange.
  1. Install the wheel stud.
    1. Install 4 washers onto the wheel stud.
    2. Install the wheel nut. Tighten the wheel nut until the wheel stud seats fully onto the wheel hub flange.
    2. Fig 1: Installing Wheel Stud
    GF0013826Courtesy of FORD MOTOR CO.
  2. Remove the wheel nut and washers.
  3. Install the brake disc.
  4. Position the caliper and anchor plate assembly onto the steering knuckle, and install the bolts.
    • To install, tighten to 160 Nm (118 lb-ft).
  5. Install the wheel and tire. For additional information, refer to WHEELS & TIRES article.
    6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  6. If equipped with a fire suppression system, repower the system.
scientia non olet · About LEMON Manuals