LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Front Suspension) >> Removal And Installation >> Ball Joint - Lower >> Removal

Ball Joint - Lower: Removal

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle ,
  2. Remove and discard the lower ball joint snap ring.
  3. Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, remove the lower ball joint.
    4. Fig 1: Removing Lower Ball Joint
    GF0013833Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals