Ball Joint - Lower: Installation
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, install the lower ball joint.
- Install the ball joint snap ring.
- Install the wheel knuckle. For additional information, refer to Wheel Knuckle ,
NOTE:
Do not damage the lower ball joint boot when installing the ball joint or premature failure of the ball joint may occur.
NOTE:
Make sure the ball joint snap ring is fully seated.