LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Handles, Locks, Latches & Entry Systems) >> Removal & Installation >> Luggage Compartment Lid Lock Cylinder >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.
  1. Remove the license plate housing. For additional information, refer to EXTERIOR TRIM & ORNAMENTATION article.
  2. Release the clips and disconnect the luggage compartment lid lock cylinder cable.
  3. If equipped, disconnect the luggage compartment anti-theft inhibit switch electrical connector.
  4. Remove the 2 luggage compartment lid lock cylinder rivets.
  5. Remove the luggage compartment lid lock cylinder.
  6. To install, reverse the removal procedure.
    • Use the special tool to install the new rivets.
scientia non olet · About LEMON Manuals